CAT
CAT 3126B Fault Code: 84-08 PID: Flash Code 36 SPN: FMI: Vehicle Speed Out of Range
Posted by Diezel Solutions on
The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector solenoid.
CAT 3126B Fault Code: 84-10 PID: Flash Code 36 SPN: FMI: Vehicle Speed Rate of Change
Posted by Diezel Solutions on
The Ecm detects one of the following after attempting to actuacte the injector solenoid: – An open circuit in the injector wiring. – An internal open circuit in the injector solenoid.
CAT 3126B Fault Code: 91-08 PID: Flash Code 32 SPN: FMI: Invalid Throttle Signal
Posted by Diezel Solutions on
The Speed/Timing signal or Engine Speed/Timing Sensor #2 is lost and then returns (intermittent).
CAT 3126B Fault Code: 91-13 PID: Flash Code 28 SPN: FMI: Throttle Sensor Calibration
Posted by Diezel Solutions on
During the last 90 seconds of the idle shutdown mode after the Check Engine/Service Soon Lamp begins to flash, the brake or clutch pedal is depressed or released. NOTE: This diagnostic code represents an event and not Electronic system fault.
CAT 3126B Fault Code: 96-03 PID: Flash Code 00 SPN: 96 FMI: 3 Fuel Level Voltage High
Posted by Diezel Solutions on
The Engine Control Module (ECM) detects the following condition: •The primary fuel level signal voltage is above the acceptable range for more than ten seconds. The fuel level sensors are OEM installed components for the vehicle. The sensors are selectable through a customer programmable parameter and the customer programmable parameter may be protected by customer passwords. Possible Causes: 1) Loose ECM Connection/Harness2) Fuel level sensor failure3) WIring between fuel level sensor & ECM