CAT
CAT 3126B Fault Code: 253-02 PID: Flash Code 56 SPN: 630 FMI: 2 Check Customer or System Parameters
Posted by Diezel Solutions on
The supply voltage for all engine sensors (except Speed/Timing and Throttle Position) is below normal level.
CAT 3126B Fault Code: 253-14 PID: Flash Code 56 SPN: FMI: Truck Manufacturer Paremater Not Programmed
Posted by Diezel Solutions on
The “Truck Manufacturer Parameter” has not been programmed. The parameter must be programmed for the manufacturer of the chassis in order to configure the correct options and ranges for the engine. Note: The “Truck Manufacturer Parameter” must be programmed before the “Customer Parameters” are programmed. Probable Causes: 1) ECM not programmed correctly
CAT 3126B Fault Code: 3-11 PID: Flash Code 73 SPN: 653 FMI: 11 Cylinder #3 Injector current fault
Posted by Diezel Solutions on
The Engine Control Module (ECM) detects one of the following items after attempting to operate the injector: •A low current condition (open circuit) exists in the wiring for the cylinder injector solenoid.•A high current condition (short circuit) exists in the injector solenoid. Probable Causes: 1) ECM Connection/Harness2) Cylinder injector failure3) Injector solenoid failure4) Harness from ECM to valve cover connector5) ECM failure6) Injector harness under valve cover
CAT 3126B Fault Code: 30-08 PID: Flash Code 29 SPN: FMI: Invalid PTO Throttle Signal
Posted by Diezel Solutions on
The idle timer has expired to stop the engine. NOTE: This diagnostic code represents an event and not an Electronic System fault.
CAT 3126B Fault Code: 30-13 PID: Flash Code 29 SPN: FMI: PTO Throttle Sensor Calibration
Posted by Diezel Solutions on
The Personality Module installed is for a different engine than the Personality Module it replaced. NOTICE: Do not attempt to install a 3126 Personality Mofule into a 3116 engine or a 3116 Personality Module into a 3126 engine. Serious engine damage may occur when the engine is started.